Posté le: 03.03.2012, 11:29:57 Sujet du message: D8/ lightning hybride mod
voici les pièces nécessaires pour faire un D8 à la Tess...
Ok guys, I've been getting ton of PM's about my D8/LP2 car so here's the scoop...
First off, the Shock towers were cut by SNR Graphite in SoCal as far as team development goes Josh, Mike gonzo, and I believe Jesse were running these towers for the last 8 months or so on the Ve8 with great success. The rear geometry is between the 112mm and Truggy tower the middle hole is the same as the inner hole on the Truggy tower. Also the front tower is slightly wider and lower than stock plus you get 2 new camber positions on both towers.
Front parts
c8017 (you use a 5x51mm turnbuckle as a camber link)
C8010-1
C8116
c8011-1
c8119
c8078
c8081 or c8081-1
c8014
c8013
c8005-1
C8134
HBS67174 (92mm WCE axles)
8x16 bearings (4 pieces) _________________ Reporteur universel - Adore les planches,JQ,les petites marques et les petites femmes xxx Anti-UE
Vous ne pouvez pas poster de nouveaux sujets dans ce forum Vous ne pouvez pas répondre aux sujets dans ce forum Vous ne pouvez pas éditer vos messages dans ce forum Vous ne pouvez pas supprimer vos messages dans ce forum Vous ne pouvez pas voter dans les sondages de ce forum